Quote:
Originally Posted by munters
Thanks eugen
Thats what I will try sunday.
Why do you run those numbers. Did you have some issues or just to be on the save side? (which is also my point)
By the way what baud rate do you use with the SD100
I dont have a handshake till now (Paranis synchronised)
Thanks again
|
V2 is pretty new, I like to be on the save side. Had no issues with the predefined torque settings from Vishnu but others did, AFAIK @ redline. In addition I have an AT.
When you change the torque settings the ECU has to adopt again. Especially when you change from higher torque settings to lower ones, take your time before you rev up to redline under full load.
The posted settings work very well.
- Eugen