Quote:
Originally Posted by JoeyJoeJo
Yeah sorry, demon plates is same company, you need to phone for custom sizing tho. They also did the BS and plate maker text in grey for me so compliant but near invisible, they've done that "slogan" text in different colours previously too.
Pads were just regular 3mm Bek-fix, I'm very particular on plates and frequently change so usually have some around, also took 6mm with me in case needed at the bottom curve but the profile in the middle is almost flat.
The only minor thing that gets on my nerves that I might change at some point is that the 11mm margin at the bottom is applied from the bottom of the reg digit to the top of the BS text so there's actually an extra couple of mm at the bottom so the main reg isn't exactly centred vertically. No one else sees it but the folks on here probably can.
The maker/BS can be 7mm from the digit and min 3mm high so the plate could actually be 101mm with the reg centred and I'd go less into the lower section.
|
Just ordering my plate and I got a bit confused here.
So what’s the smallest size you could do whilst keeping the reg centred?