[BabyM240i]

Originally Posted by MPR

I loaded mine up with around 5 stainless washers and used a longer bolt, as I had to make room for the SS mesh over the square holes.

M10-1.5 x 30mm Flanged Hex Head... https://www.amazon.com/dp/B082TNT68H...p_mob_ap_share

20Pcs M10 Stainless Flat... https://www.amazon.com/dp/B0CG5YPM3C...p_mob_ap_share

Did those bolt right into the factory holes? This was for the back two bolts correct? Did you do anything different for the front four screws? I think I stripped one and now with my lip they could be a few threads longer. .