Quote:
Originally Posted by tylerdurdem
When I got PPF done, either I forgot to tell the installer or I told them and they forgot that I didn't want the strip under the trunk lid done. I just hate the visible seam. Anyway, I had them take it off, and a while later I noticed the center of the bumper where it meets the trunk lid has basically no gap anymore. I've tried just putting weight on it to get it to stay down, but to no avail. I have no idea what's going on under there, is there an attachment point that may have been broken? Maybe they used a heat gun on it and it's deformed? Not sure what the fix would be here.
 |
I think they took the bumper off during install or take off and didn't put it back on properly. The front bumper has little slots that the actual bumper falls into, i'm sure the rear is exactly the same. To fix it, take off the entire bumper and realign and install. I'm sure there's a plastic piece that goes into a tab that in this case, went over the tab.