05-24-2023, 09:03 AM | #1 |
Private
6
Rep 58
Posts |
Error E7146F after FEM coding
Hey, after coding FEM module with esys this error keeps popping up. Could someone advise on what variable to change to fix this?
|
05-24-2023, 09:43 AM | #2 |
Private First Class
41
Rep 161
Posts |
Fault Information
Fault Code Description The control units exchange information via the bus. An "interface error" (invalid signal) is stored when urgently required signals are only received in the form of a substitute value or as an "invalid signal". The fault is logged when the partner control unit (=interface) transmits a substitute value or a value designated as invalid instead of the required information. In this case, a fault code should also be stored in the corresponding partner control unit. Fault Code Conditions General Conditions Supply voltage between 9 and 16 volts. Terminal Condition Terminal 15 on Terminal Condition PWF status: Driving Terminal Condition PWF status: Residing Driving Conditions Note: The designations of terminal status or PWF status apply according to the vehicle electrical system of the vehicle. Fault Time Condition The fault code is entered after starting the control unit after a maximum of 10 seconds. Service Plan Work through all stored faults of the partner control unit according to the test plan. Especially faults that affect the vicinity of the partner control unit (e.g. connected sensor system). These types of faults are consequential faults. If there are no further test modules in the test plan then no further repair measures are required. Fault Impact Warnings Warning Lights Control Center Messages Service Notes The fault is not in the control unit that records the interface fault. For this reason the control unit must not be replaced. |
Appreciate
0
|
05-24-2023, 10:26 AM | #4 |
Private
6
Rep 58
Posts |
|
Appreciate
0
|
05-11-2024, 08:49 PM | #10 | |
Registered
0
Rep 1
Posts |
Quote:
you find the Problem? i have the Same Problem and i Cant find it to fix. https://ibb.co/25JStgL |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|