Need advice before buying

alddiem415 · 09-21-2017, 07:10 PM

I have a 2011 335i xdrive lowered on koni yellow/eibach setup

Im planning on buying a used set of forgestar f14

Front 19 x 8.5 offset 31 235/35/19 tire
Rear 19 x 10 offset 32 265/30/19 tire

Will these fit without any issue like rubbing?

Do i need fender work? I have no plan on doing any fender work.

Do i need a new set of lugs for these wheels?if so, what kind of lugs

Please let me know before i pick these up
Thanks

jwebb335xi · 09-21-2017, 08:27 PM

Quote:

Originally Posted by alddiem415

I have a 2011 335i xdrive lowered on koni yellow/eibach setup

Im planning on buying a used set of forgestar f14

Front 19 x 8.5 offset 31 235/35/19 tire
Rear 19 x 10 offset 32 265/30/19 tire

Will these fit without any issue like rubbing?

Do i need fender work? I have no plan on doing any fender work.

Do i need a new set of lugs for these wheels?if so, what kind of lugs

Please let me know before i pick these up
Thanks

Check the APEX wheel section. When I did my research on wheel/tire size for my car, I noticed there were many discussions about what people had tried , what was recommended, what was discouraged and what fell into gray zones..

Ryan at Apex was really helpful too.

vadimlitv · 10-02-2017, 10:40 PM

Not sure about the offsets of my my wheels, but I got same width and height and same tires. I'm lowered on ycw coilovers. And they fit no problems , no fender work. I ordered through **********s. Also they came with bolts that are a little tiny bit longer.

bill109 · 10-05-2017, 06:49 PM

Quote:

Originally Posted by vadimlitv

Not sure about the offsets of my my wheels, but I got same width and height and same tires. I'm lowered on ycw coilovers. And they fit no problems , no fender work. I ordered through **********s. Also they came with bolts that are a little tiny bit longer.

Could you post pictures?

JETmn · 10-06-2017, 08:37 AM

The rears will be a little tight on an LCI car. We have a little wider track and that leaves less room. A fender roll might be needed in the back, front should be good. Front is .8% bigger than the rear too, getting towards the top of what is considered ok.

TemjinX2 · 10-06-2017, 04:19 PM

why not go with a square setup so you can route the tires and reduce understeer?

09-21-2017, 07:10 PM	#1
alddiem415 Private First Class 41 Rep 158 Posts Drives: 2011 335i xdrive Join Date: Dec 2016 Location: 08096 iTrader: (0)	Need advice before buying I have a 2011 335i xdrive lowered on koni yellow/eibach setup Im planning on buying a used set of forgestar f14 Front 19 x 8.5 offset 31 235/35/19 tire Rear 19 x 10 offset 32 265/30/19 tire Will these fit without any issue like rubbing? Do i need fender work? I have no plan on doing any fender work. Do i need a new set of lugs for these wheels?if so, what kind of lugs Please let me know before i pick these up Thanks
	Appreciate 0 Tweet Quote

10-02-2017, 10:40 PM	#3
vadimlitv Enlisted Member 3 Rep 43 Posts Drives: 2008 e90 335xi Join Date: Oct 2015 Location: Portland, OR iTrader: (1)	Not sure about the offsets of my my wheels, but I got same width and height and same tires. I'm lowered on ycw coilovers. And they fit no problems , no fender work. I ordered through **********s. Also they came with bolts that are a little tiny bit longer.
	Appreciate 0 Quote

10-06-2017, 08:37 AM	#5
JETmn Lieutenant Colonel 247 Rep 1,595 Posts Drives: 2011 335i xDrive Msport Join Date: Apr 2013 Location: Orlando iTrader: (0) Garage List 2011 335Xi [0.00]	The rears will be a little tight on an LCI car. We have a little wider track and that leaves less room. A fender roll might be needed in the back, front should be good. Front is .8% bigger than the rear too, getting towards the top of what is considered ok. __________________ 2011 335Xi 6AT - VRSF catless DP - VRSF 7" FMIC with turbo inlet pipe - VRSF chargepipe - Pure Stage 1 turbo - JB4 - E30 - xHP Stage 3 - Strongflex tension bushings - Whiteline RSFB - UUC rear swaybar
	Appreciate 0 Quote

10-06-2017, 04:19 PM	#6
TemjinX2 Major 535 Rep 1,499 Posts Drives: 2008 335xi e92 Join Date: Dec 2009 Location: Socal OC iTrader: (0)	why not go with a square setup so you can route the tires and reduce understeer?
	Appreciate 0 Quote