[e90slut]

So I installed some cpe downpipes and have had issues ever since.
Other mods are
DCI, Procede rev 2.5, aa exhaust

I originally thought it was just an o2 sensor. but now the problem is back
I start the car and my rpms bounce between 1000-1500 and awd,dcs, and engine malfunction codes are on. It sounds like some sort of leak when the car is off.

I reset all the adaptations with the procede and it will start normally randomly. As soon as the car shuts off same exact thing. I notice my intake was a little loose so I make sure that was all tight and removed procede. After uninstalling procede same issue,
reinstalled procede it started 2 times normally after resetting adaptations with awd codes till on , then when i bolted everything up first start still same issue.

There are NO dme codes its just messing up.


has anyone else experienced this issue? I have a couple data logs but only codes it thew were

PRocede 10703 - cylinder 3 misfire
and 2DED 11757 - electrical issue?

[e90slut]

And a video for your viewing pleasure..

[e90slut]

no one has any idea?? ? ? ? ?

- firmware on procede ??
- throttle body itself
- procede connections

ANYONE>>>@??!?!?!?!?!?!?!

[e90slut]

Well.. Turns out I had v4 software still on my computer and that was causing these issues..