[nate5ks]

Has anybody set up ISTA/P and ISTA/D to work with an ICOM clone? I just purchased one and I'm a little lost. I found some info on the other forum about needing something called Itool Radar which I looked for and found but the file is password protected. Can somebody provide step by step instructions on how to set this up?

[nate5ks]

It's an actual icom with most connection and everything but its a clone from china, not an original. It didn't come with any instructions or software, just a few adapters and an Ethernet cable.

[nate5ks]

Much appreciated, are you able to pm me? Before you weren't. If not, my email address is nate5ks@gmail.com

[nate5ks]

My ICOM isn't showing up in Itool Radar, am I doing something wrong? Do I need to change any settings on my network adapter?

[nate5ks]

Does the icom use the car as a power source?

[nate5ks]

Thanks, got itool to work. Do I just use the self assigned IP address and set one of the networks in virtual network editor?

[cn555ic]

Use the IP address that is assigned from I tool radar. Did you get it to work for NCS and other tools?

Email me. I have something to ask you
Ccnoner@aol.com

[nate5ks]

Originally Posted by cn555ic

Use the IP address that is assigned from I tool radar. Did you get it to work for NCS and other tools?

Email me. I have something to ask you
Ccnoner@aol.com

Not yet, I'm more concerned about getting it to work with ista/p. I use a dcan with ncsexpert. Sent you an email.