[NEFARIOUS]

I got a new RR window regulator, then I followed the whole roll down/up scheme to calibrate it, and it worked fine...

...But the 2nd week onward (including now), it won't roll back up one-touch or manually unless I tap the window switch in short bursts until it's at least 1/2" (2cm) up, and that's for both the door side and driver's door switch.

I tried redoing the calibration steps but it didn't do anything, and it's got plenty of grease in the tracks, so I know it's not stuck or anything.

Any solutions?

[NEFARIOUS]

Any answers, please? I've been saying "BUMP" for a week now!!

[NEFARIOUS]

Anyone, anything?

[xxxjecxxx]

Get someone with INPA to reset it for you.

[GB-335xiCoupe]

You did the hold for 15 seconds and all that jazz???
Did you shake the chicken leg in the air while dancing counterclockwise? This step is the most important.

[NEFARIOUS]

Originally Posted by xxxjecxxx

Get someone with INPA to reset it for you.

I plan to do an FW upgrade and make a few internal tweaks (e.g. auto up enabled when door is open), so I am considering one myself. Which section / code do I change?

Originally Posted by GB-335xiCoupe

You did the hold for 15 seconds and all that jazz???
Did you shake the chicken leg in the air while dancing counterclockwise? This step is the most important.

I thought it was clockwise at first, but I tried the counterclockwise and it didn't work either. It worked once when I dug up the Macarena from the bellows of the late 90's and it almost worked once though.