Sponsored by The Tire Rack

[JJBA223]

For reference see the following forum:
http://www.e90post.com/forums/showthread.php?t=566191

Originally Posted by Bendercle

Gonna revive this thread, I'm attempting to disable TPMS in my 2007 E90.

I removed fuses 13 and 28, removed $2VB from my VO, did FA_WRITE to CAS, used Expertmode to reset CAS, BDSC, KOMBI, and NFRM. It was mostly successful. Before, I would get the light constantly, the one flashing on the dash and the big one in the cluster display. Now the light doesn't come on any more while I'm driving, but it still comes on just once right when I start the car then goes away. I did not try setting RDC_ALIVE to nicht_aktiv, or unplug the RDC module. I will try RDC_ALIVE right away, but I would prefer to not have to mess with the module in the trunk, just because from the DIY OP posted it looks like a hassle. Any insight?

What do all those acronyms mean?

[Aashenfox]

I believe they are references to ECU codes and 'coding', the act of getting inside your BMW's ECU and messing around with the actual software to change or remove entire functions, but I could be wrong.

[JJBA223]

What are these ?
$2VB
VO
FA_WRITE
CAS
Expertmode
CAS, BDSC, KOMBI, and NFRM.

[Eat.Sleep.Race]

Jb4 with tire pressure sensor delete. endthread/

[jwzimm]

Go to the CODING section and start reading.

[JJBA223]

Originally Posted by Eat.Sleep.Race

Jb4 with tire pressure sensor delete. endthread/

And when I remove jb4?

[e92_boost]

On JB4 speedo 4 tach 6 bye bye TPMS (will only come on when you turn on the car for a few seconds it will flash and go away but I always press the BC button I think it was called on the left side where you have your turn signal and it goes away so it doesn't blink it's just a habit I do it every time lol)

When you remove JB4 you are screwed you lol