[pxinrorh]

Hello forum members ;

2011 BMW e90 brand I bought for my car and I put the cruise control .
I get the above error . (for picture)
What should I do now ?
What can I do with the calibration program?

Errors car ;

DBC , RPA , DSC E90 Cruise control retrofit ?

[W37V]

Did you scan the cars for actual codes that are causing this? This error could be caused by many different things (e.g. Steering angle sensor, DME failure, ABS unit failure, etc.). Without more specifics, it's hard to tell.

You can try clearing codes and see if error comes back. Sometimes, things need to be calibrated, so clearing codes is #1 step.

Double check what you did. A lose wire in steering column (if you didn't connect it properly) can cause this error as well.

PS. Please do not write in Comic Sans and huge font.

[Wilt]

steering wheel angle sensor is in the steering column, you might have disconnected something inadvertantly or it might merely need to be recalibrated

[pxinrorh]

So what I need to do this calibration programs ? Do I need to do with NCS expert

[feuer]

When I was replacing my cluster I ended up with cruise control error. My coder used NCS Expert. It could be done remotely you just need a obd2 to usb cable.

[AWDBooSTIn90]

So you did a cruise control retrofit?

Did you do a VO change to add cruise control (dynamic cruise control NOT active cruise control), then code all modules to new VO specs, by "coding car" with NCSexpert.

VO is called FA in NCS

[pxinrorh]

Originally Posted by AWDBooSTIn90

So you did a cruise control retrofit?

Did you do a VO change to add cruise control (dynamic cruise control NOT active cruise control), then code all modules to new VO specs, by "coding car" with NCSexpert.

VO is called FA in NCS

I am succesfully changed Vehicle order and i coded my CAS module. (CRUISE_CONTROL nich_aktiv to aktiv)

Do I need to do another coding module?

Which software is applicable for the calibration of the steering angle sensor, if any software is avaliable, how can i set up? Could you please help me?

[pxinrorh]

Originally Posted by feuer

When I was replacing my cluster I ended up with cruise control error. My coder used NCS Expert. It could be done remotely you just need a obd2 to usb cable.

I have OBD2 to USB Cable.

Can you ask him what he was doing code changes with NCS Expert?

[AWDBooSTIn90]

Originally Posted by pxinrorh

I have OBD2 to USB Cable.

Can you ask him what he was doing code changes with NCS Expert?

Just pull the VO from CAS like you normally would when opening NCS. Then click process car. Then click code car. It will code all ecus and only make changes where necessary for the VO change. DONE

[Nitrousbird]

These cars didn't all come standard with cruise control? Yikes!

[feuer]

Originally Posted by Nitrousbird

These cars didn't all come standard with cruise control? Yikes!

In NA yes...

[feuer]

Originally Posted by pxinrorh

I have OBD2 to USB Cable.

Can you ask him what he was doing code changes with NCS Expert?

Contact my friend directly via email. I PM'ed you the email address. Good luck!