[Blaze439]

Hey everyone, I have been researching this for a few nights now and I keep seeing conflicting or incomplete processes. I bought a new SMC module for my driver side adaptive headlight (PN:63127189312) because the left (driver) headlight was not moving and it kept getting the adaptive error on my BC. I used inpa to clear the code but forgot to write it down. I have the new module installed and I am ready to code it. Based on my research I plan to do the following:

Using bimmergeeks standard tools and winkfp updated with current E90 spdaten file:

WinkFP to code the vin in the FRM2:
1.Comfort mode
2.Enter ZUSB
3.Update ZUSB
4.ENTER VIN
5.Programm

Once that is done...

NCS Epert:
A:
1.open NCS expert
2.File-Load profile
3.select FACTORY CODING (for bimmergeeks software)
4.press F1
5.press F3
6.select E89<for E90>
7.press BACK
8.press F3<CHOOSE ECU>
9.select NFRM
10.select FA_WRITE from CHANGE JOB
11.press F3<EXECUTE JOB>
12.select SG_CODIEREN from CHANGE JOB
13.press F3<EXECUTE JOB>

Will this get my module coded and AHL working again? or brick something? any feedback is greatly appreciated. Sorry for I just want to get this right.

[Blaze439]

Anyone?

[Joe@TopGearSolutions]

No need to flash the FRM. You only need to use NCS to default code the LSMC.

[Blaze439]

Originally Posted by Joe@TopGearSolutions

No need to flash the FRM. You only need to use NCS to default code the LSMC.

Would that only require my ncs steps above but with the lscm module selected?