[WoodE30]

OK, I recently installed the JB4 bluetooth kit and did some logs. Over at N54tech.com I was advise to reset my JB4 to default settings. After doing that my charge pipe meth injection stopped working. Ive tried every different setting through the JB4 app, even set it back to how it was when it was working but still wont get any flow. Its like the system is off, but the weird thing is I can purge/prime the system through the steering wheel controls.

Any ideas? Thanks.

[HKD126]

Post a screenshot of your settings in the app.

[WoodE30]

Originally Posted by HKD126

Post a screenshot of your settings in the app.

here there are.

[Fuel-It!]

Log?

[blown07]

Do you have the solenoid wired for PWM to match you settings?
If so what do you have your PWM settings at under "fuel bias"?
Using the steering wheel controls have you actually verified that fluid is coming out using a bucket?

[WoodE30]

Originally Posted by Fuel-It!

Log?

I tried uploading the csv file but it failed to upload. ill try again when I get home.

[WoodE30]

Originally Posted by blown07

Do you have the solenoid wired for PWM to match you settings?
If so what do you have your PWM settings at under "fuel bias"?
Using the steering wheel controls have you actually verified that fluid is coming out using a bucket?

Im going to double check all my connections, but nothing change as for wiring. It just stopped working. Yes, using the steering wheel menu I am able to purge/prime the system with the gas pedal, that's what's weird. Also i'm not getting the meth flow on the oil temp like it use to.

[WoodE30]

ok, i think i figure out uploading the logs,


with meth

https://datazap.me/u/woode30/log-156...=0&data=1-4-16

without meth

https://datazap.me/u/woode30/log-156...=0&data=1-4-16

[Fuel-It!]

Maybe you just turned off the gauge? It's showing meth flow in your log.

[blown07]

Originally Posted by WoodE30

Im going to double check all my connections, but nothing change as for wiring. It just stopped working. Yes, using the steering wheel menu I am able to purge/prime the system with the gas pedal, that's what's weird. Also i'm not getting the meth flow on the oil temp like it use to.

With PWM selected the guage doesn't show flow when priming with gas pedal. Do you understand that to have the PWM selected requires different solenoid wiring than standard and custom Fuel bias settings?

[WoodE30]

Originally Posted by blown07

With PWM selected the guage doesn't show flow when priming with gas pedal. Do you understand that to have the PWM selected requires different solenoid wiring than standard and custom Fuel bias settings?

yeah i figured it out. it was my fuel bias. I was told to set my everything to default and i found a screen shot of default and fuel bias was 0 across the board. I set mine to 50 across the board and now im getting flow.