[FREQUENCY 24.7]

Anyone come across the line to code out error 9cb6 lwr coil? Also knows as Headlight vertical aim control break.

I swapped out the pre -LCI halogens and put in pre-LCI OEM adaptive Bi-xenons. I don't have or need the adaptive functions but Im getting the error now. Everything else works as it should, I edited the VO with the 522 and default coded the FRM and saved it back to CAS and FRM. All is well except this one error.

[FREQUENCY 24.7]

I did more research and thought if I deleted $524 from VO- it would take care of it, but 524 has already been deleted. Now Im stumped.

[lowrydr310]

Did you ever figure this out? I just swapped to xenons and did the right coding yet this is the only error I have.

[FREQUENCY 24.7]

Originally Posted by lowrydr310

Did you ever figure this out? I just swapped to xenons and did the right coding yet this is the only error I have.

I used ProTool to solve it, but it was so long ago now, I honestly can't remember what the solution was. If i come across it, Ill post back up.

[Terraphantm]

Originally Posted by FREQUENCY 24.7

I did more research and thought if I deleted $524 from VO- it would take care of it, but 524 has already been deleted. Now Im stumped.

Delete $522 also

[lowrydr310]

Originally Posted by Terraphantm

Delete $522 also

That removes the xenon option.

At a minimum $522 disables the cold low beam bulb check, but after adding $522 there are quite a few other changes in my FRM TRC file besides the low beam cold check.

When doing my conversion, I originally added $522 to my VO and reprogrammed CAS and (halogen) FRM modules, disabling the auto leveling via coding, but got this error. I then replaced my FRM with one that actually supports xenons (needed to get the shutter trigger signal - my old halogen FRM didn't support this). I reprogrammed the replacement FRM with my VIN and VO and disabled the AUTO_LWR_ENABLE, but also found an option DYNAM_LWR_ENABLE which I also disabled. There is no 9CB6 error any more with this configuration.