![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
![]() |
![]() ![]() |
BMW 3-Series (E90 E92) Forum
>
N57 - Popping Leak Off Pipe
![]() |
![]() |
03-14-2021, 08:55 AM | #1 |
New Member
1
Rep 9
Posts |
N57 - Popping Leak Off Pipe
Hi Guys,
Trust everyone keeping safe! My N57 - ran perfectly until Fuel Return line was replaced because of damage to OEM Line. It was replaced with OEM part. Since then - third gear Open Throttle - the return line on the Injectors Pop off - this is the OEM crimped Ends - they jus pop off. I have stripped the car over 10 times to try and figure out what could the issue be. With the old pipe that was "repaired" never had any issues - since the repaired pipe was replaced with OEM pipe - I have had this issue ![]() Reason for replacing repaired pipe - Used Q-bond to stick Nipple back on - but broke after 2 weeks. But it was an awesome 2 weeks ![]() So...back to the Issue...any ideas what i can look at? I was thinking injectors - but how can injectors just fail by replacing a pipe? |
03-14-2021, 12:38 PM | #3 |
New Member
1
Rep 9
Posts |
Hi,
First Blue Circle in the centre - Runs to Injector Return - this Pops off...if this does NOT pop off...then the OEM crimps on the Injector return Pops off :-( https://ibb.co/SxxHZYW |
Appreciate
0
|
03-14-2021, 04:26 PM | #5 |
Second Lieutenant
![]() ![]() 80
Rep 270
Posts |
did you install them on properly? they need to go on quite far down and you need to get a click when you pop the locking bit back into place.
or are you missing an o-ring which came off during replacement? they are tiny little things and slide on the return section of the injector. |
Appreciate
0
|
03-14-2021, 04:37 PM | #6 |
New Member
1
Rep 9
Posts |
All installed correctly...
I was thinking bad injector...but can it just die within 20Minutes of just replacing a damaged Pipe? Hope not... Now I am assuming could be something stuck in the Main fuel return line going to tank... just didnt want to strip - thought some-one here may have experienced the same issue. |
Appreciate
0
|
03-20-2021, 05:19 AM | #9 |
New Member
1
Rep 9
Posts |
So.. have had a look at injector values on ISTA...
All 5 injectors average 0.1 to 0.3 on idle...Only Cylinder 3 stays at 1.5...and as i rev up...it goes to 3.0...didnt rev higher, but I assume it would go up as well. So next question... is the injector dead? Could this be causing excessive pressure on the Return Line? |
Appreciate
0
|
![]() |
Bookmarks |
Thread Tools | Search this Thread |
|
|