|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Recharging AC with R134
|
|
05-26-2015, 01:44 PM | #45 |
Lieutenant Colonel
182
Rep 1,681
Posts |
If you don't replace anything, probably not. Vacuuming the system won't remove the oil since it won't turn to vapor like water and exit the system. You'd only need to replace oil if you replaced parts. I added like 2 oz to mine after replacing the condenser since the drier is attached to it and each needs ~1oz. It's been 2 years and so far, the AC continues to work normally.
|
Appreciate
0
|
05-26-2015, 02:12 PM | #46 | |
Second Lieutenant
18
Rep 283
Posts |
Quote:
Not replacing anything, just completely refilling the system (evac and fill) just want to be sure I'm not forgetting anything.
__________________
335i Coupe 6MT Montego Blue
|
|
Appreciate
0
|
09-28-2015, 09:47 AM | #47 |
Leeeroy Jankins
31
Rep 423
Posts |
Thanks for the post, everyone's comments helpful. Fingers crossed the psi holds. I was barely in the green (upper 20's) for psi and added enough to get up to midway blue which was around 35psi. Blowing cold for now.
__________________
e90 LCI w/ -= VRSF 7" FMIC =-
-= Cobb: Stg1 +FMIC Aggressive ST =- Last Install: BMS DCI + Caliper/Drum Paint "If you're not 1st, you're last" -Ricky Bobby |
Appreciate
0
|
09-28-2015, 07:29 PM | #48 |
Private
10
Rep 84
Posts |
I bought my E91 and I just thought the a/c in these cars was crappy. I bought a recharge kit from Autozone for like 30 bucks. Hooked it up and gave maybe 8 seconds total of charging in very long intervals. Car blows ice cold now. It really doesn't take much refrigerant so little is better.
|
Appreciate
0
|
08-07-2017, 09:15 PM | #49 |
Registered
0
Rep 2
Posts |
I just added R134a to my system, here are my results. Welcoming feedback
2008 car, 80k miles. Don't think the AC system has ever been touched.
After running engine for 10 mins AC full blast, LOW side measured 25 PSI, high side 115, 76 degree outside temp. Added 134a from a 12oz can, let it sit for about 10 minutes. Can is maybe 2/3 empty now. After running AC for a while on full blast, now have 34 PSI low end and the high end is way up at 205 PSI. AC is working very well. Should I be worried by this major jump in high end pressure? any thoughts? Thanks!! |
Appreciate
0
|
08-08-2017, 09:15 AM | #50 |
Lieutenant Colonel
182
Rep 1,681
Posts |
High side should be something like twice ambient temperature + 50 degrees. So 205 psi sounds fine if it was 75-80 degrees when you did this. 30-35psi on the low side is good as well.
|
Appreciate
0
|
08-23-2017, 02:40 AM | #51 |
First Lieutenant
89
Rep 325
Posts |
I'm looking to recharge my AC with 134a. I haven't done it before and I don't think the previous owners have. My AC isn't blowing as cold as I would like it to. Since this'll be my first time recharging with 134a, would a single 12oz can do the trick or does it need more/less?
|
Appreciate
0
|
07-02-2018, 02:00 PM | #52 |
Colonel
922
Rep 2,109
Posts |
Having the same issue with my AC, gonna try 134a today
__________________
MGM F82 M4 DCT / MPerformance / Swift / CSF / IND / Turner / BimmerWorld
BSM F87 M2 6MT / Fabspeed / MPerformance / Turner / AutoID - SOLD JB-NB E92 M3 6MT / IND / RTD / Alpine / KW / ActiveAutowerke / 360Carbon - SOLD SS2-FR E90 M3 6MT / IND / AFE / ActiveAutowerke - SOLD AW-FR E90 M3 DCT / ACM / IND / AutoTecknic / K&N / H&R / Bilstein - SOLD |
Appreciate
0
|
07-13-2018, 01:54 PM | #54 |
Lieutenant Colonel
113
Rep 1,951
Posts |
I strongly suggest you 3 read through the full thread - there are a lot of ways to screw this up, and while they PROBABLY won't destroy anything, you COULD mess up your pump and anyway, diagnosing is pretty difficult.
The PROPER way to charge the system is by mass, not pressure - you drain the system completely, pull a vacuum, and charge the proper amount by weight. That is, get a 18oz can if you can find it, or else measure the weight of the can as you fill (which is as tough as it sounds, gotta keep unscrewing it to weigh it, and hope you don't overshoot). Anyway, it's not TERRIBLY hard with a proper manifold gauge and vacuum pump, which you can rent or borrow. But if you just use one of those stupid cans with a gauge on it, you're ASKING to screw it up. And if you overcharge, it won't blow cold, you'll think you've undercharged, and charging more could nuke your compressor. EDIT erm, 2 of you. But to answer DYOOS's question a year late, NO. 12oz won't do it, unless you are, by some miracle of chance, exactly 12oz short (and if you are, there's a big leak you should get professionally sorted out).
__________________
|
Appreciate
1
DYOOS89.00 |
07-14-2018, 02:58 AM | #55 | |
First Lieutenant
89
Rep 325
Posts |
Quote:
__________________
IG: @dyoos335i
|
|
Appreciate
0
|
07-14-2018, 01:39 PM | #56 |
Lieutenant Colonel
113
Rep 1,951
Posts |
Hahaha, happy to "help" - what was your outcome in the end?
__________________
|
Appreciate
0
|
07-15-2018, 06:22 PM | #57 |
First Lieutenant
89
Rep 325
Posts |
I've decided to get my AC re-charged professionally
__________________
IG: @dyoos335i
|
Appreciate
0
|
08-03-2018, 08:45 PM | #59 |
Private
30
Rep 77
Posts |
I haven't been real happy with the AC in my 2011 E90. Using a wireless thermometer stuck into the dash vent, I was getting about 64F when it was around 90F outside. I have a Foxwell NT520 and it gave some interesting readings:
Footwell temp: 86 Evaporator temp: 57 Compartment temp: 82 Refridgerant pressure: 16.5 bar Ventillation temp: 66 And a gauge on the low pressure end said 45 psi. It is confusing as the pressures changes quite a bit as the engine rev's. That was after adding a little and then pulling the car out of the garage. When it was in the garage (maybe 95 degrees) it was getting up to 19 bar. I'm not really sure what the AC should be capable of in terms of temperature drop from the outside air source to what's coming out of the vents. |
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|