[OpenFlash]

Originally Posted by TurboSid

shiv or anyone that knows, i asked in the other thread about whether there is a gauge available for the procede that I can monitor afr's and other parameters without having to install additional sensors? I dont like driving around with my laptop on

'Fraid not. The gauge will only show basic OBD values like rear o2 voltage, applied throttle, etc,. Not the enhanced CAN channels that are more useful (wideband o2, actual throttle angle, etc,.) And even if it did display wideband o2, it wouldn't correct it for the voltage bias that the Procede applies.

Shiv

[dzenno]

This available yet?

[OpenFlash]

Yep: http://www.e90post.com/forums/showpo...4&postcount=27

But Leanrun protected beta maps will be posted tomorrow.

[dzenno]

shiv, we getting the leanrun beta maps today in private beta?

[OpenFlash]

Originally Posted by dzenno

shiv, we getting the leanrun beta maps today in private beta?

That's the plan. Won't be until tonight though. So u probably won't be able to run them until tomorrow.

Shiv

[Undies]

maybe a stupid question, but how come the headings are still i.e., CAN knock and no the proper name?

[jpsimon]

Originally Posted by Undies

maybe a stupid question, but how come the headings are still i.e., CAN knock and no the proper name?

cause he hadn't changed the names yet

[OpenFlash]

Originally Posted by Undies

maybe a stupid question, but how come the headings are still i.e., CAN knock and no the proper name?

Because we haven't gotten around to updating that part of the user software. All the recent front end edits were done with a basic resource editor. The "proper" name is there so it's easy to follow. But it's in the Units section.

Shv

[Undies]

Originally Posted by jpsimon

cause he hadn't changed the names yet

i guess some ppl post for posting sake rather than actually add value to the thread.

i just asked a simple question, and shiv gave me a reasonable programming related answer....

[Tiago@VRSF]

Hey Shiv,

Any way to get it to convert whatever the Procede does to get that signal to a 5v output so we can hook this bad boy up to an AFR gauge?

[Luyen]

Hi shiv,

can i use 6at map for my n54 335 with 7 speed dct ?

[Glowin]

Originally Posted by Undies

i guess some ppl post for posting sake rather than actually add value to the thread.

i just asked a simple question, and shiv gave me a reasonable programming related answer....

He answered you the way he did because if you'd followed any of Shiv's posts in the last 6 months, you'd have known it's quite standard for him to start using older fields for a different use, but he doesn't update the user software right away each time.

This has happened at least 3 times I'd say in the last 6 months with various parameters.

[jpsimon]

Originally Posted by Undies

i guess some ppl post for posting sake rather than actually add value to the thread.

i just asked a simple question, and shiv gave me a reasonable programming related answer....

you asked a dumb question and I gave a dumb answer. what other possible reason could it be that they were mislabeled shiv used more words to say the same thing i did

[Former_Boosted_IS]

Originally Posted by shiv@vishnu

Compare recovery times after the deccel/fuel cut after i revved the engine. Procede updates the afr display 10x/sec. Quite a bit faster than the handheld display.

Shiv, my log rate, sensitivity, and sensor response are lightning fast compared to that LM2. I am logging 30+ data points per second on my FJO. I would love to see a log like mine versus a procede AFR log.