|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
335i performance software flash
|
|
07-04-2011, 02:42 PM | #1 |
Second Lieutenant
16
Rep 245
Posts |
335i performance software flash
Available in the GTA. Gains are 80 hp at the crank on 6 MT cars. From now till July 17, get your 335i flashed for $750 plus HST -> $847.50
MarkD |
07-04-2011, 03:29 PM | #2 |
Second Lieutenant
11
Rep 205
Posts |
Mark... your killing it... My base Dyno run is on the 23rd? Can we make arrangements to do it thereafter? I really want a base run first... plus it'll benefit you too as I'm willing to share the the pre and post with you
I'm sure we can come to an arrangement no? |
Appreciate
0
|
07-04-2011, 04:54 PM | #3 | |
Second Lieutenant
16
Rep 245
Posts |
Quote:
By now I had expected to have a few cars dyno'd there but it's not that easy to get them over there. This has prompted me to get my friend's dyno running again at GRAF AUTO on Bentworth Ave. (Near Yorkdale) It will take roughly 6 to 8 weeks to get the parts required to upgrade the dyno, but once it is done we can easily get dyno runs done on a Saturday. Here is where it is located: http://www.grafautocentre.aaro.ca/ It's not as close as Champion Motors, but should be quite central for most people. I've started this thread since nobody has contacted me since I made my initial post. I had one 335i that I flashed had various problems that had to be sorted out, such as a bad O2 sensor, fuel pump, and intercooler leak! All these repairs were scheduled at the dealer by the shop I use in Richmond Hill. Now the owner is away for a month so no dyno results till August for that car. |
|
Appreciate
0
|
07-05-2011, 09:19 AM | #5 |
Second Lieutenant
11
Rep 205
Posts |
the graf auto centre location is fine as far as location.
Did you want to book several people or should we book for ourselves? Any clue on what they charge? |
Appreciate
0
|
07-05-2011, 10:51 AM | #6 |
Second Lieutenant
16
Rep 245
Posts |
Maybe you missed the part of my post where I said I need to order some parts and get a software upgrade from Germany, My guess is that this could take about two months. I'll post here when it's all ready to go.
|
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|