[QUIKDZL]

Originally Posted by 335dlci

Another question for those who have their tank in the trunk. Which route are you using for running your hose. I ran mine through the the back seat to the kick panel trim into the dash but the back seat pinches it off when my fold downs are latched in.

My rear seat doesn't fold down (wish it did), but the same latching mechanism has to be manually operated to remove the seatback. I ran mine from under the driver's side storage compartment over the wheel arch along with the wires already there, and then along the carpet edge at door thresholds to the left kick panel and through the firewall using a wire grommet. No pinching at all.

[Chief Orman]

Originally Posted by 335dsleeper

I have a bulk head fitting in the truck floor. Tube goes from pump to bulkhead, from bulkhead to over the subframe on the driver side and then follows the fuel lines all the way to the engine compartment.

Same... You may want to consider steel braided lines of you plan on running high concentrations of meth

[335dsleeper]

^ why

[335dlci]

I am just using some clear plastic hose I bought at a hardware store. It was like 20¢ a foot.

[335dlci]

Originally Posted by QUIKDZL

My rear seat doesn't fold down (wish it did), but the same latching mechanism has to be manually operated to remove the seatback. I ran mine from under the driver's side storage compartment over the wheel arch along with the wires already there, and then along the carpet edge at door thresholds to the left kick panel and through the firewall using a wire grommet. No pinching at all.

mine is currently tucked under the kick panel trim and trough the grommet currently but it's the seat that's pinching it :\. One of these weekends I'll get around to rerouting it