[achu]

I am so sorry if this has been solved previously but I can't find anyone with an issue like mine...

Last night I cleared a few codes with the JB4 and then just checked my settings as it had been so long since I ever did anything with it...

I don't think I did much, I just toggled things like MaxCool for fun... But this morning, the car would stick in gauge hijack mode... I tried turning off the car and starting it again, it showed fuel and oil temp for about 3 seconds and then flicked back to hijack mode with the car sitting at idle...

I went to 5-6 to toggle stealth mode and the gauges went all messed up, as if they had the wrong calibration (so when I went through the JB4 menus, it'd go 1, 3, 4.5 sorta thing)... I did 5-2 and all returned to normal, but the hijack was still on!

Repeatedly tried to toggle stealth mode and nada, it just messes up the gauges every time...

I tried toggling the sweep and that worked fine so i'm fully lost

Anyways, as I need to know my fuel and oil temp I've just turned off the hijacks from menu 2 and 7...

I'm thinking to just go home, connect up my laptop and reset (and maybe update if available) the JB4?

[achu]

Anybody?

[BMB063]

Not sure if this will answer your question, but in map 0, there is definitely no hijack mode...

[OneMoreAlex]

Did you try 5-2 with the car not running?

[Mike@N54Tuning.com]

Settings have changed recently. Ensure you have the latest firmware and are using the latest wheel control guide.

http://www.n54tech.com/forums/showthread.php?t=10605

Mike