|
|
|
|
 |
 |
 |
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
 |
|
BMW 3-Series (E90 E92) Forum
>
Question on Forge DVs installation
|
 |
| 04-06-2010, 06:01 PM | #1 |
|
Major
 
60
Rep 1,065
Posts
Drives: RB PWRED E90 N54 6MT
Join Date: Aug 2006
Location: Bellevue, WA
|
Question on Forge DVs installation
Installed Forge DVs and took the car out for a spin. The peak boost I was getting was 12.7 psi instead of 15.x psi or 16.1 psi prior to the installation. I'm currently running JB3 2.0 map 7. Seems like I'm getting a boost leak. As instructed, I turned the gray rings counterclockwise before I snap in the valves. I don't have to turn the gray clips clockwise after the valves are in place, do I? I'm not getting any check engine light or limp mode at this moment. So what is going on with the car?
__________________
RB Turbo/Procede V5/Vishnu PWM Meth Injection Kit/Vishnu DCI/AR Catless DP/AE Performance Exhaust(Sold)/Helix FMIC/Forge DVs/Rixster Vent Boost Gauge/Wavetrac LSD/KW V3/ACT Street Clutch Kit
|
 |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
