Question for thr DO meth install.

Jonny550 · 08-06-2010, 02:17 AM

I was wondering where should i wire the LED flow indicator. After the relay or before the relay. basically a LED wired to the pump to tell me the pump has power and its flowing.

Also i get a free low level indicator with this kit. Do i just wire the ground to the pump and the positive to the LED?.

Jonny550 · 08-06-2010, 12:58 PM

ttt

cn555ic · 08-06-2010, 02:37 PM

Wire it before the relay....thats what I did...when the pump red wire has power then the LED will light up...simple as that.

08-06-2010, 02:17 AM	#1
Jonny550 Brigadier General 269 Rep 4,936 Posts Drives: 2012 550i Xdrive Join Date: Feb 2009 Location: Jersey Shore iTrader: (14)	I was wondering where should i wire the LED flow indicator. After the relay or before the relay. basically a LED wired to the pump to tell me the pump has power and its flowing. Also i get a free low level indicator with this kit. Do i just wire the ground to the pump and the positive to the LED?.
	Appreciate 0 Tweet Quote

08-06-2010, 12:58 PM	#2
Jonny550 Brigadier General 269 Rep 4,936 Posts Drives: 2012 550i Xdrive Join Date: Feb 2009 Location: Jersey Shore iTrader: (14)	ttt __________________ [SIGPIC][/SIGPIC] .
	Appreciate 0 Quote

08-06-2010, 02:37 PM	#3
cn555ic 485 Rep 18,331 Posts Drives: 335i Join Date: Jun 2007 Location: US iTrader: (6)	Wire it before the relay....thats what I did...when the pump red wire has power then the LED will light up...simple as that.
	Appreciate 0 Quote

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search