[Spoolin335]

I recently updated my PROcede to 6-14maps, after updating i went for a run and blew the charge pipe off. In the process of doing that, the tmap sensor wire came off as well. The clip for the connector is busted up, but the connector still sits in the holder.

I tried to clear the codes associated with the connector comming off, but they wont clear. I am assuming the sensor is probably toast now and i need a new one.

I am just wondering about the 2FO8 & 2ABC codes. Are they related to the same sensor, the tmap sensor on the charge pipe?

I should also note, my engine icon is blinking 3 times then it stops for few seconds, then it just repeats... what does this mean? That there is 3 codes?
This is not the limp mode half engine message, but an actual icon.

[nsgates23]

what was the solution?
I also blew my charge pipe off and tmap sensor clip broke but still stays somewhat. and I'm still getting limp mode and 2abc. 0_o

[Alpineis]

Any solutions? I am getting the 2ABC after Cobb install. I also blew my pipe off (fixed), but it was fine for a day before I started getting random 2ABC faults.

[08335ibmw]

Any solutions??