[Dynomyte]

Hey guys I am currently having an issue with my canadian CCC and my tpms.

My CCC crashed and I had to purchase a replacement unit. This unit is from a 2008 US car. Everything works fine but US cars use the TPM i believe with the 4 receivers in the front of each tyre and Canadian cars use FTM which I believe use the rotation speed of the tire and transmit the info to some part below the drivers feet.

I was getting the malfunction error before swapping to the new CCC though and when I used my BT tool my FTM was "not responding"

So now in my new CCC is the TPM option in my I-drive is "greyed out" I cannot select or reset it. But I am not sure if it is because my car is a FTM or because my FTM is simply malfunctioning.

How can I troubleshoot and figure out what the problem is. My tyre pressure is correct in all tyres.

I checked inside the wheel hub and there are no receivers so I am certain I do not have them.

Can the car be coded to use FTM? Anyone experienced anything like this?

Thx,
Dynomyte

[lomenop]

any body have a solution? Is there an option in CAPPL to enable the FTM menu and hide the TPM menu? Or perhaps an alternative way to reset the FTM? Perhaps some how enable the FTM reset from the cluster screen like non-idrive equipped cars?

[cyrano]

Originally Posted by Dynomyte

Hey guys I am currently having an issue with my canadian CCC and my tpms.

My CCC crashed and I had to purchase a replacement unit. This unit is from a 2008 US car. Everything works fine but US cars use the TPM i believe with the 4 receivers in the front of each tyre and Canadian cars use FTM which I believe use the rotation speed of the tire and transmit the info to some part below the drivers feet.

I was getting the malfunction error before swapping to the new CCC though and when I used my BT tool my FTM was "not responding"

So now in my new CCC is the TPM option in my I-drive is "greyed out" I cannot select or reset it. But I am not sure if it is because my car is a FTM or because my FTM is simply malfunctioning.

How can I troubleshoot and figure out what the problem is. My tyre pressure is correct in all tyres.

I checked inside the wheel hub and there are no receivers so I am certain I do not have them.

Can the car be coded to use FTM? Anyone experienced anything like this?

Thx,
Dynomyte

Try to recode CCAPL module with exper profile and revert it to its default settings using your cars VO,

[lomenop]

What put the option in the cluster, like non-idrive cars, was coding KOMBI. Changing MMI_ENA_RPA_RDC to aktiv. Now at least I can reset from the BC button.

[Dynomyte]

My problem went away after I got the car recoded to recognize the new CCC I installed.