[pilotstephen]

IFH-0003 Datatransmission to Interface Disturbed

Bought this cable:
http://www.ebay.com/itm/110839153399...84.m1497.l2649

2009 335i Coupe
Windows 7 Starter 32bit on Lenovo Netbook

Ediabas 6.4.7
INPA 5.0

COM Port auto installs as 3, changed to COM 1
Latency set to 1 as recommended
FIFO buffers set to 8 in registry

Uninstalled Windows COM port drivers that were auto installed when cable plugged in
Installed latest drivers from FTDI website v2.08.14 (plug has a FTDI labelled chip inside)

Ediabas set to correct OBD interface
INPALOAD appears to be up and running. Two black dots (battery and ignition)

Load e90 [F9]

Goto Karosserie > airbag then get IFH-0003 error

Cable originally had pins 7 and 8 soldered together. I removed the solder bridge and even physically removed pin 8. Still getting the IFH-0003 error.

Re-installed pin 8 and resoldered/bridged pins 7/8 (currently)

Are Ediabas 6.4.7 and INPA 5.0 compatible with a 2009 335i?

I specifically need to do diagnostics on my airbags due to airbag deployed icon showing after replacing with new airbags.

Any other suggestions?

[cn555ic]

Originally Posted by pilotstephen

IFH-0003 Datatransmission to Interface Disturbed

Bought this cable:
http://www.ebay.com/itm/110839153399...84.m1497.l2649

2009 335i Coupe
Windows 7 Starter 32bit on Lenovo Netbook

Ediabas 6.4.7
INPA 5.0

COM Port auto installs as 3, changed to COM 1
Latency set to 1 as recommended
FIFO buffers set to 8 in registry

Uninstalled Windows COM port drivers that were auto installed when cable plugged in
Installed latest drivers from FTDI website v2.08.14 (plug has a FTDI labelled chip inside)

Ediabas set to correct OBD interface
INPALOAD appears to be up and running. Two black dots (battery and ignition)

Load e90 [F9]

Goto Karosserie > airbag then get IFH-0003 error

Cable originally had pins 7 and 8 soldered together. I removed the solder bridge and even physically removed pin 8. Still getting the IFH-0003 error.

Re-installed pin 8 and resoldered/bridged pins 7/8 (currently)

Are Ediabas 6.4.7 and INPA 5.0 compatible with a 2009 335i?

I specifically need to do diagnostics on my airbags due to airbag deployed icon showing after replacing with new airbags.

Any other suggestions?

Alot of cars the airbags dont register or work...I dont think you have an issue with cable...Try to see if other functions work with INPA like the engine..If it reads the engine modules then your out of luck with the airbag function

[J-Spec Dan]

I had some issues as well and decided to install XP mode on my Windows 7 Home Primo laptop. Worked after that for me.

[icuc]

I had the same problem with my Windows XP but worked fine on my Windows 7 x32.

[Alvine90]

i solved this problem by deleting the NCS Ediabas and Inpa folders in C:\\ and extracting the files from the archive again. it worked when i was using xp. I'm running 7 now.