[litz4244]

I have a procede v5 rev 2.5. I am fbo and meth. Past 2 nights in map 4 I keep getting a procede error code 5. ses light flashing 5 times. That is on the orginal aggresive maps. I searched the vishnu fourm and all i could find was trouble codes 1 through 4. i though maybe it was in the map or software.So today I installed rbs and uploaded the 4-23 maps off the vishnu website. But in map 4 i am still getting trouble code 5. I cant find anywhere what trouble code 5 is. Thanks.

[E3r2E9r]

What is your injection mode set to and what is your meth flowing? I'm just guessing but that might be a code for meth overflow.

[OpenFlash]

Yes, that's just a meth overflow fault. Raise your injection mode value closer to the max meth flow value you see in your logs. That code triggers with meth flow is 10 higher than the injection mode value. We put that in there so people don't run too low a meth target value which limits the effectiveness of the methanol failsafe.

[litz4244]

Ok thanks guys for the fast response. Makes sense since I have it at 14 and it was reading as high as 28 to 30. I have a cm12 and do7 nozzle. What kind of boost do u recommend with rbs?

[OpenFlash]

Originally Posted by litz4244

Ok thanks guys for the fast response. Makes sense since I have it at 14 and it was reading as high as 28 to 30. I have a cm12 and do7 nozzle. What kind of boost do u recommend with rbs?

Yes, that will do it. Raise it up to 25 and you should be good.

As for boost with RBs, I'd say 17-18psi is good for pump+meth.

[litz4244]

Originally Posted by shiv@vishnu

Yes, that will do it. Raise it up to 25 and you should be good.

As for boost with RBs, I'd say 17-18psi is good for pump+meth.

Ok thank you very much for all your help.