[E36graduate]

I hear you....I can drive the car as it is, but anytime the meth starts pumping the clutch will slip the first couple of times and then the slippage goes away...not sure why?

[E36graduate]

I purchased the Spec 2+ and Steel FW without SAC......Am I supposed to buy the following parts to replace the old bolts/screws?

11227520706 ISA Screws (look like bolts to me) and there are 8 on a 1/2008......Will the new steel flywheel have 8 holes? Do these screws need to be replaced?

21207536792 Roller bearing....I'm assuming the Kit and/or Steel FW would have this part shipped with the kit?

11227557611 Dowell....not sure about this part?

There is also a "dowell" listed as #2 on the OEM diagram but no part number?

I'm assuming the pressure plate has its own screws in the KIT.......

Also, does anyone have the torque specs for all of these screws/bolts? Don't worry, I'm not doing this clutch job by myself, however I wanted to prepare for when we do this!