|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Low boost no codes
|
|
08-12-2013, 04:49 PM | #1 |
Captain
11
Rep 645
Posts |
Low boost no codes
So a few days ago a code popped p30ff. Cleared it and couldn't get it to come back but on stg2+fmic I was maxing at 14psi and on stock only 4psi. Still now throwing any codes. Check all the vacuum lines and canister. Then smoked tests everything up to 18psi with no leaks at all. Now I'm lost as to where to look now?
|
08-12-2013, 06:08 PM | #2 |
3472
Rep 79,211
Posts
Drives: C6 Z06, 09 335i, 10 335xi
Join Date: Dec 2008
Location: www.TopGearSolutions.com
|
You need to underboost for over 3 seconds to throw a 30FF.
Just cause you have no leaks doesn't mean your not underboosting. You could have bad boost solenoids or sticky wastegates. |
Appreciate
0
|
08-12-2013, 06:27 PM | #4 |
3472
Rep 79,211
Posts
Drives: C6 Z06, 09 335i, 10 335xi
Join Date: Dec 2008
Location: www.TopGearSolutions.com
|
So no codes but you are still saying your low on boost?
It's probably best to throw up a datalog. Ideally, 3rd gear, WOT from 2500 to redline. Throttle RPM Boost Air Fuel Ignition Wastegate Duty Cycle IAT |
Appreciate
0
|
08-12-2013, 08:19 PM | #6 |
First Lieutenant
9
Rep 334
Posts |
I have a similar issue running Cobb. I threw an underboost code once a month ago but haven't thrown anything since. I'm only hitting about 14psi on Cobb stage 2+ when I check my logs for req boost vs mean boost it seems to be hitting where its supposed to but when I was first running it on stage 1+ it was hitting 18.5.
|
Appreciate
0
|
11-18-2013, 07:40 AM | #8 |
Major General
161
Rep 7,377
Posts |
if no leaks than probably either boost solenoid shot or wg issue. i bet on the solenoid.
__________________
07 335i AT - MOTIV 750 - MHD E85 BMS flash - BMS PI - JB4G5 - Okada Coils - NGK 5992 Plugs - Helix IC - Snow Stg. 3 - Stett CP - Custom midpipes with 100 HJS Cats - Bastuck Quad - PSS10 - QUAIFE LSD - BMS OCC - Forge DVs - AR OC - ALCON BBK - M3 Chassi - Dinan CP - Velocity M rear Toe arms - Advan RZ-DF - LUX H8 - Level 10 AT upgrade
|
Appreciate
0
|
11-18-2013, 07:55 AM | #9 |
Private
5
Rep 54
Posts |
Sorry for me me being stupid but I dont know what the waste gate is. I think I have low boost dont see any leaks. I dont know how to check the boost pressure. My engine is making a louder noise above 3000rpm. The one mechanic said its one of the injectors but I doubt it. No smoke at all. Everything sounds good if accelerating slowly. When accelerating hard its a bit lazy and the engine noise is much louder
|
Appreciate
0
|
11-18-2013, 11:07 AM | #10 | |
BimmerPost Supporting Vendor
15
Rep 678
Posts |
Quote:
|
|
Appreciate
0
|
11-18-2013, 11:25 AM | #12 |
Private
5
Rep 54
Posts |
The car is standard didnt tune anything. I dont like messing around with it. It has enough power as it is. I changed fuel filter,oil,coolant, brake fluid, air filter. The damper pulley stripped and the power steering pump broke. Replaced everything with genuine bmw parts. I might not have bleeded the cooling system perfectly.
|
Appreciate
0
|
Bookmarks |
|
|