[>sVo<]

Originally Posted by GenePoole

The two connections on the Dension are...

I have a E90 with idrive and no CDC.
I followed GenePoole's diagram (with UUDDD DIP settings) and now it works like a dream and NO SOS Error.
I dont have anything else to add... Just wanted to say THANK YOU!!!

[farms5]

Originally Posted by GenePoole

You can't have 2 CDCs in the loop and the dension shows up as a CDC to the system. Like you said, disconnecting the CDC breaks the MOST bus. You need that little loop connector, or you need to disconnect it at the junction box under the rear seat back (as shown in this post: http://www.e90post.com/forums/showthread.php?t=4194). The only other option is to mount the Dension near the CDC and wire it as per the Dension manual (or run new fiber cables all the way from the CDC in the trunk to the other jack on the Dension behind your dash, but that's a stretch). The second jack on the Dension is to retain the CDC, but only when switched in and out of the loop by the bypass switch.

Hi Genepoole, was wondering if you could give me some help.
Looking to buy and install a gateway 500 with streaming audio bluetooth.
I have an 07, 335i with navi, i drive, aux in armrest (no usb), bluetooth for phone, wired for CD changer but no actual changer, wired for satellit

I was going to install the Dension in the trunk. Do I connect the Dension and hen get coded and any suggestions on how to connect the power.

Appreciate the help.

Mike

[Rickygst]

I have the same setup and looking at the Dension with BT streaming. looking for the best way to install
thanks