[brettp]

Hi, sorry for the urgency but looking to try get this completed this afternoon.

I purchased the Technic 2/4 Harness and I am stuck on where to split / run the wires to.

In the pack I have a black and red set and I have assumed they run from each sub with a connector. This is fine as I have already run these in already.

I then have a pair of bi wire speaker cables (4 wires in each) at one end there is a BMW connector that would connect to the female side of the connector on each side. That used to connect to the sub.

On the other end it is just a cut wire with no instructions of what each wire goes to. At a guess I would 'presume' 2 wires are a feed, so these would need to be connected to a RCA and then to the amp. The remaining 2 would connect to the amp as a feed for the front speakers.

Is that correct? if so anyone any idea on what cables would do what?

Thank you in advance.

Brett

[Technic]

A diagram with the instructions was sent to you... check your email or Spam folder.

If you do not find it/was deleted then unfortunately it will take until next week to send you a replacement diagram as I am in Germany right now.

Sorry for the inconvenience if that is the case...

In the meantime:

white cable = red/black = OEM HU high level outputs +/-
white cable = blue/yellow = front OEM speakers inputs +/-

[brettp]

Oh my god, Thankyou for much it was in my junk. I'm so sorry for the trouble.

Brett

Originally Posted by Technic

A diagram with the instructions was sent to you... check your email or Spam folder.

If you do not find it/was deleted then unfortunately it will take until next week to send you a replacement diagram as I am in Germany right now.

Sorry for the inconvenience if that is the case...

In the meantime:

white cable = red/black = OEM HU high level outputs +/-
white cable = blue/yellow = front OEM speakers inputs +/-