|
|
|
|
 |
 
|
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
Suspension help. Quick
|
 |
| 03-23-2015, 03:27 PM | #1 |
|
Boosty
56
Rep 329
Posts |
Suspension help. Quick
I know it's in the wrong section but this gets the most attention.
My drivers rear strut is loose and I think that is what is causing the car to make a clunking sound in the back. I put a socket on the top nut and turn it but it's not tightening... It just keeps spinning the silver "arm" or what ever it's cause and I'm not getting more threads exposed. What's the trick to getting this tight??
__________________
'08 335i AT Alpina Flash~Rob Beck Turbos~Full kittyless exhaust~DCI~5" Intercooler~Chargepipe BOV~BMS meth kit
|
| 03-23-2015, 03:43 PM | #2 |
|
Colonel
178
Rep 2,346
Posts |
take the nut off and check to see if the threads are stripped. If it is you could add a washer on it to tighten it up just to hold you over.
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
|
Appreciate
0
|
| 03-23-2015, 04:06 PM | #3 |
|
Boosty
56
Rep 329
Posts |
I put a vise grip on the bottom part and tightened it. Thanks !!
__________________
'08 335i AT Alpina Flash~Rob Beck Turbos~Full kittyless exhaust~DCI~5" Intercooler~Chargepipe BOV~BMS meth kit
|
|
Appreciate
0
|
 |
| Bookmarks |
|
|
