[Fishayyy]

So I finished my install of an ER Charge Pipe with a Turbosmart BOV today but when I turned on the car I got the half engine light and used my cobb to read the codes and I got P2ABC and P2F08. During the install I managed to break the little clip on my Tmap sensor but I used elctric tape to make sure it stayed in place when I put it back and it is very secure. I checked to see if I could feel any leaks anywhere and the only one I could feel/ hear was a little air from the silicon hose connector that connects the CP to the FMIC. I'm noy sure if its a leak or the sensor that's the problem, any ideas??

[Levanime]

p2abc boost sensor electric
p2f08 intake air temp sensor

your tmap sensor is not sitting well

[Fishayyy]

Originally Posted by Levanime

p2abc boost sensor electric
p2f08 intake air temp sensor

your tmap sensor is not sitting well

I'll go double check to see if it's plugged in correct. I double checked it to make sure but it can't hurt to look again lol

[924er]

Originally Posted by Fishayyy

I'll go double check to see if it's plugged in correct. I double checked it to make sure but it can't hurt to look again lol

How did u manage to break it? Don't u just have to squeeze it and it comes out?

[Fishayyy]

I just loosened and re-tightened the clamps and unplugged the Tmap sensor (which was plugged in correctly) and re-plugged it back in with out the tape and everything is in working order now. I'll come back to this if I run into any more problems.

[Fishayyy]

Originally Posted by 924er

How did u manage to break it? Don't u just have to squeeze it and it comes out?

Mine was kinda stuck inthere so I tried to lift the little clip a little while pushing on it and it broke lol