|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
N54 misfire/hesitation between 2500 and 4500 rpm
|
|
12-31-2014, 07:19 PM | #1 |
New Member
1
Rep 5
Posts |
N54 misfire/hesitation between 2500 and 4500 rpm
I have a 2008 N54 335i with about 75k miles. It recently developed a misfire/hesitation between 2500 and 4500rpm. It is an auto but the misfire is most prominent when I hold full throttle in a high gear. Above 4500rpm the engine runs fine all the time.
I had similar misfire issues about 5k miles ago and replaced the coils and plugs which fixed the issues. The car has a JB4 and the issue is there with the JB4 off but is less severe. I don't get any fault codes. Anyone have any ideas? Given the problem happens in the mid range, it seems like another electrical problem but given the coils and plus are fairly new, it seems unlikely? The car idles like a clock and outside of the 2500-4500 rpm range, runs absolutely fine. |
12-31-2014, 07:55 PM | #2 | |
Major
34
Rep 1,093
Posts |
Quote:
Official Misfire Thread
__________________
07 335XI (A008006) 6AT ~94K miles JB4 G5 ISO VSRF DP's
09 135I M (VK80379) 6MT. Race Project car. 1) Install Cobb/piggyback? and Motiv 600 Kit[HTA3076R w/ tial .82] 2) JRZ or Moton suspension. 3) Build high flow intake manifold with multi-port fuel and relocate OFH 4) Build full cage 5) Complete staged twin setup with HTA4205R [w/Tial 1.16] 6) Complete dry sump system |
|
Appreciate
0
|
12-31-2014, 07:56 PM | #3 |
Colonel
535
Rep 2,872
Posts |
Did the misfire go away after replacing the plugs/coils at all? Which type of plugs are you using?
I'd say try to get a log of it happening without going crazy risking damage or something. It could be fuel related too, which a log may help us see.
__________________
BSM E90 6MT-JB4 G5 ISO-BMS DCI-Golf-Tee Mod-Hankook S1N2 Non-RFT-ER Chargepipe/TiAL BOV-E40 blend-VRSF V2's-M3 CDV-MHD/JB4 FLASH-VRSF 5" STEPPED FMIC
|
Appreciate
0
|
12-31-2014, 08:51 PM | #4 | |
New Member
1
Rep 5
Posts |
Quote:
I have pulled the JB4 off to see if that was the issue. I will put it back on and try to take some logs. |
|
Appreciate
0
|
12-31-2014, 11:20 PM | #7 | |
Lieutenant
40
Rep 592
Posts |
Quote:
Good luck.
__________________
Evolution Racewerks FMIC and Charge Pipe with TIAL-Q.
Wedge Tuned 93 Oct, K&N Panel, Conti DWS 245/275. |
|
Appreciate
0
|
12-31-2014, 11:31 PM | #8 |
Colonel
535
Rep 2,872
Posts |
You're using the correct plug right?
|
Appreciate
0
|
01-01-2015, 06:21 AM | #10 |
New Member
1
Rep 5
Posts |
|
Appreciate
0
|
07-07-2015, 11:55 AM | #13 |
BimmerPost Supporting Vendor
27324
Rep 196,604
Posts |
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
Bookmarks |
|
|