|
|
|
|
 |
 |
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
Procede Rev 3 won't shift DCT in auto n55
|
 |
| 08-23-2015, 04:49 PM | #1 |
|
Lieutenant
 
271
Rep 437
Posts |
Procede Rev 3 won't shift DCT in auto n55
Hey guys,
I'm having a bit of an issue with my Procede and quite frankly I'm about to toss the thing and go for a JB4 ( which I should of gotten to start with) Anyways I installed it, Loaded the n55 11-08 DCT maps with the proper firmware Ran through the 12 commands No issues No CEL But when I threw it into map 1 and started driving it would not shift out of first gear. It would peak to the shift point and then kind of jerk and stay in first when it should of shifted to second. As of right now I have uninstalled it and everything is fine, no cels nothing. And it shifts fine I noticed upon first starting it after I had installed it, that it went through a 15-20 second revving phase.. Could this be part of the problem? Or is it normal? As the ecu needs to adapt?? I know Vishnu and Procede are basically extinct now but maybe there is someone out there who can give me a hand?
__________________
 |
 |
| Bookmarks |
|
|
