[deeLow]

I am getting a lighting system error on the CIC and in Rheingold the fault reads out "Software version and coding index do not match". What gives? I didn't do anything else, and I haven't done anything to the FRM module besides a little custom coding a long time ago.

I noticed in NCSExpert when selecting Frm module it goes from FRM2 .C08 before being read to FRM3 .C32 after its read. Does this have anything to do with it?

[nate16]

Originally Posted by deeLow

I am getting a lighting system error on the CIC and in Rheingold the fault reads out "Software version and coding index do not match". What gives? I didn't do anything else, and I haven't done anything to the FRM module besides a little custom coding a long time ago.

I noticed in NCSExpert when selecting Frm module it goes from FRM2 .C08 before being read to FRM3 .C32 after its read. Does this have anything to do with it?

Is your VIN right on the FRM module? also have you run a blank sg_codieren on the module?

[deeLow]

Originally Posted by nate16

Is your VIN right on the FRM module? also have you run a blank sg_codieren on the module?

I'm pretty sure when I get the vin in ncs from cas,frm,nfrm they all match. I haven't tried sg cod yet, should I with expertmod profile?

I tried fa write with revtors profile with a blank man file and it didn't even clear my custom coding.

[nate16]

can you run an AIF in inpa?

[deeLow]

Originally Posted by nate16

can you run an AIF in inpa?

Here

[deeLow]

Edit x2.

Finally worked. NOW I just have to redo my custom coding.