![]() |
![]() |
![]() |
![]() |
![]() ![]() |
![]() |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
![]() |
![]() ![]() |
BMW 3-Series (E90 E92) Forum
>
Which o2 sensors do I have to replace?
![]() |
![]() |
06-18-2016, 11:17 PM | #1 |
New Member
0
Rep 15
Posts |
Which o2 sensors do I have to replace?
I have 2C32 Lambda code and also a 2C6C lambda code, and it's now affecting how my rpm reacts to my pedal input. On 2 occasions recently the car threw a half engine light, after I restarted the car the boost deactivation mode disappeared.
I took it to a dealer a while back and they said it was my rear o2 sensor after the catalytic converter. I think was caused by a leaking injector (#6) that i replaced in January. At the time I didn't want to change the o2 sensor after the cat because I was going to go castles dp eventually. I didn't think the o2 sensor after the cat would affect my driveability so I think my bank 2 primary o2 sensor is also bad. I just want to confirm it before I buy both o2 sensors. My exhaust almost smells catless and after driving for a while, it smells like mothballs. I have all cats in place and I am assuming one or more of my catalytic converters are burnt up. I have 2 unknown codes that I looked up but didn't find any information on them. 2A7C and 2FDB. Thank you. |
![]() |
Bookmarks |
|
|