[DarrenO]

Good morning guys,

I've noticed that after a bit of time I've forgot to code the Kombi when I retrofitted the CIC unit (service intervals aren't changing or dropping down in mileage). I've scanned through various searches in the past week or so and I've not found anything too clear regarding instructions on "how to". Would anyone be kind enough to help me out on this one with a "how to" please 🤔.

[Sensible_]

Originally Posted by DarrenO

Good morning guys,

I've noticed that after a bit of time I've forgot to code the Kombi when I retrofitted the CIC unit (service intervals aren't changing or dropping down in mileage). I've scanned through various searches in the past week or so and I've not found anything too clear regarding instructions on "how to". Would anyone be kind enough to help me out on this one with a "how to" please 🤔.

You need to code KOMBI to default with NCS Expert and an expertmode profile.

The factory expertenmodus (wekstellung) profile works well for this. In the profile settings just make sure manipulation is NOT checked.

Off the top of my head:

1. Open NCSEXPERT
2. File, Load Profile - any expert mode profile
3. F1 (VIN/ZCS/FA)
4. F3 (ZCS/FA f .ECU)
5. Choose E89 (for the E9X)
6. Select CAS
7. F6 (BACK)
8. F4 (Process ECU)
9. Select KOMBI from list
10. F2(CHANGE JOB)->Choose "SG_Codieren->OK
11. F3->to start coding the ecu with factory settings according to the vehicle VO/FA

[DarrenO]

Originally Posted by Sensible_

You need to code KOMBI to default with NCS Expert and an expertmode profile.

The factory expertenmodus (wekstellung) profile works well for this. In the profile settings just make sure manipulation is NOT checked.

Off the top of my head:

1. Open NCSEXPERT
2. File, Load Profile - any expert mode profile
3. F1 (VIN/ZCS/FA)
4. F3 (ZCS/FA f .ECU)
5. Choose E89 (for the E9X)
6. Select CAS
7. F6 (BACK)
8. F4 (Process ECU)
9. Select KOMBI from list
10. F2(CHANGE JOB)->Choose "SG_Codieren->OK
11. F3->to start coding the ecu with factory settings according to the vehicle VO/FA

Thanks again mate 😉 Off the top of my head, this looks very familiar 👌🏻

Last time I used NCS Expert to do the retrofit it worked fine, think the lappy com-port settings have changed since (com prob to the car). If I've got a bit of time later I'll give this a go again.