|
|
|
|
 |
 
|
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
clicking noise from driveshaft area
|
 |
| 07-06-2017, 07:42 PM | #1 |
|
Enlisted Member
 1
Rep 34
Posts |
clicking noise from driveshaft area
Anybody experience a sort of clicking noise from the rear end? sort of sounds like under the rear seats. it goes away once you get above 10-15 mph.
|
| 07-06-2017, 09:56 PM | #2 |
|
First Lieutenant
 
187
Rep 337
Posts |
Do you get any vibration ahen accelerating from standstill? If so, your driveshaft might be chipped and slightly out of balance.
The noise could also be a bad center support bearing. If you remove the drive shaft make sure to mark the existing balance point of the 2 halves. You'll need to reinsert to 2 halves in that exact spot in order to maintain balance. |
| 07-09-2017, 12:06 AM | #3 |
|
First Lieutenant
42
Rep 348
Posts |
See this at the shop all the time- if its in first and going into second gear its 99% your driveshaft support bearing. Have a shop pull back your exhaust shield and verify by driving it under load.
__________________
07 E92 MT RB Turbos(All options)/ VTT Inlets/ VRSF 7In IC/ VRSF DP/Vangaurd Exhaust/AFE intake/Stett CP with Tial BOV/BT CC/ Meth Dual CM10s/ E85 Walbro Pump(E50)/JB4 with BB "e85" flash
|
 |
| Bookmarks |
|
|
