|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Home made camber plates
|
|
07-07-2017, 11:26 AM | #1 |
Private
40
Rep 97
Posts
Drives: 2009 335i
Join Date: Feb 2017
Location: Houston, TX
|
Home made camber plates
This is what I did to my e90.
I water jet cut two 11 ga steel plates and TIG welded them to the ID hole in the towers. Once in place I used a rotary tool to slot the towers to match the slots in the plates. The slots allow for returning camber to OEM position. After an alignment both sides are at -2.1° camber. There are also tabs on the front for attaching a strut tower brace. At the moment that brace is a piece of tubing. Eventually I will roll a piece of tube into a gently arc and weld in bushings to the bolt holes.
__________________
FBO, Vargas Stg 1, lots of cooling and proper maintenance.
|
07-07-2017, 02:02 PM | #4 |
Private
40
Rep 97
Posts
Drives: 2009 335i
Join Date: Feb 2017
Location: Houston, TX
|
Not a bad idea. I could provide the plates and verticals for the bar. Anyone who can handle the welding can certainly get a piece of pipe and drill some holes.
__________________
FBO, Vargas Stg 1, lots of cooling and proper maintenance.
|
Appreciate
2
feuer4282.50 |
Bookmarks |
|
|