[NCSUPack24]

First, let me start with a simple question. The BMW Alarm system from the factory comes with an audible "beep" when unlocking and locking the doors, correct? I have done all the steps I can find online to code/install this thing, but yet it doesn't beep when locking/unlocking.

So far have done the following:

1) Added $302 to the VO in NCS to both the CAS and NFRM
2) After reading that I needed to "restore factory settings" after adding it to the VO, I proceeded to clear out the .MAN file (using the Manipulation profile) in the WORK folder of NCSEXPERT, select the CAS and NFRM (individually), choose CODIEREN as the job, and execute. Get out and hit the lock button... nothing
3) Read that I should have manipulation off, so I made sure to choose a profile with it unchecked. Follow the same steps as #2, and nothing

What am I missing here? Any help is great.

[Joe@TopGearSolutions]

Do you have any DWA* modules listed in NCS to choose from? Have you tested that the sensors operate properly (i.e., pop hood while alarm is active)?

[PichaDis11]

Originally Posted by PGAHopeful26

First, let me start with a simple question. The BMW Alarm system from the factory comes with an audible "beep" when unlocking and locking the doors, correct? I have done all the steps I can find online to code/install this thing, but yet it doesn't beep when locking/unlocking.

So far have done the following:

1) Added $302 to the VO in NCS to both the CAS and NFRM
2) After reading that I needed to "restore factory settings" after adding it to the VO, I proceeded to clear out the .MAN file (using the Manipulation profile) in the WORK folder of NCSEXPERT, select the CAS and NFRM (individually), choose CODIEREN as the job, and execute. Get out and hit the lock button... nothing
3) Read that I should have manipulation off, so I made sure to choose a profile with it unchecked. Follow the same steps as #2, and nothing

What am I missing here? Any help is great.

Forget Clearing out your MAN file. Just use expert mode profile then select SG_Coderen.

If $302 doesn't help. You will need to use +K302. This is what worked for my car. I coded (Expert mode) CAS, NFRM, JBE and then Alarm modules.

[jsanchez335]

Originally Posted by PGAHopeful26

First, let me start with a simple question. The BMW Alarm system from the factory comes with an audible "beep" when unlocking and locking the doors, correct? I have done all the steps I can find online to code/install this thing, but yet it doesn't beep when locking/unlocking.

So far have done the following:

1) Added $302 to the VO in NCS to both the CAS and NFRM
2) After reading that I needed to "restore factory settings" after adding it to the VO, I proceeded to clear out the .MAN file (using the Manipulation profile) in the WORK folder of NCSEXPERT, select the CAS and NFRM (individually), choose CODIEREN as the job, and execute. Get out and hit the lock button... nothing
3) Read that I should have manipulation off, so I made sure to choose a profile with it unchecked. Follow the same steps as #2, and nothing

What am I missing here? Any help is great.

1. Add +K302 to VO
2. Write to CAS and FRM
3. Default code CAS, CAPPL, DWAI, DWAS and KOMBI
4. In DWAI, Code FUNK_INNENRAUMSCHUTZ (Interior Sensor) to Aktiv