Installed my Angel Bulb, Having trouble.

Inspired · 04-12-2008, 01:42 AM

I was installing my ICE. I was having trouble putting it on. Took me 4 hrs to figure it out on 1 side.

- My ice doesnt shut tight close. Am i suppose to take something out inside? I believe i DIDN'T TAKE off the lens. Am i suppose to?
-My left turn signal dont work anymore in the front. What did i accident take off? The rear and sidemarker only works and blink like it has no resistor.
-It was almost impossible to do this without jacking up the car/take off the wheel and fender.

DO I NEED TO REDO THIS? IS THIS NOT SAFE? the light output seems fine imo .

tom @ eas · 04-12-2008, 03:01 AM

The lens is not used with the LEDs - remove this and set it aside. Also verify that you have the LED housings in the correct positions as there is difference between Left/Right.

The rings can be a bit tricky to get to for first timers, but if the fender liner is removed, it makes the job much easier.

04-12-2008, 01:42 AM	#1
Inspired Colonel 153 Rep 2,368 Posts Drives: 335i Join Date: Dec 2007 Location: California iTrader: (2)	Installed my Angel Bulb, Having trouble. I was installing my ICE. I was having trouble putting it on. Took me 4 hrs to figure it out on 1 side. - My ice doesnt shut tight close. Am i suppose to take something out inside? I believe i DIDN'T TAKE off the lens. Am i suppose to? -My left turn signal dont work anymore in the front. What did i accident take off? The rear and sidemarker only works and blink like it has no resistor. -It was almost impossible to do this without jacking up the car/take off the wheel and fender. DO I NEED TO REDO THIS? IS THIS NOT SAFE? the light output seems fine imo . Last edited by Inspired; 10-08-2008 at 02:07 AM..
	Appreciate 0 Tweet Quote

04-12-2008, 03:01 AM	#2
tom @ eas General 8674 Rep 19,149 Posts Drives: BMW Join Date: Nov 2005 Location: Anaheim, CA iTrader: (19) Garage List 2018 BMW i3s [5.00] 2010 BMW M3 [6.50] 2015 BMW M4 [6.20]	The lens is not used with the LEDs - remove this and set it aside. Also verify that you have the LED housings in the correct positions as there is difference between Left/Right. The rings can be a bit tricky to get to for first timers, but if the fender liner is removed, it makes the job much easier. __________________ Tom G. \| european auto source (eas) email: tom@europeanautosource.com · web: https://europeanautosource.com· tel 866.669.0705 · ca: 714.369.8524 x22 GET DAILY UPDATES ON OUR BLOG · FACEBOOK · YOUTUBE · FLICKR · INSTAGRAM
	Appreciate 0 Quote