|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Mechanical Advice for 2008 335i N54
|
|
05-26-2020, 06:39 PM | #1 |
New Member
0
Rep 9
Posts |
Mechanical Advice for 2008 335i N54
Hey guys,
I'm getting the following codes but I'm not exactly sure what it could be. 2AA2 Camshaft sensor, inlet, gap loss 3100 Boost-pressure control, deactivation 2A9E Camshaft sensor, inlet, synchronization 2A9A Crankshaft - inlet camshaft, synchronization 2AA0 Camshaft sensor, inlet, signal I am currently getting a half engine light and sometimes, I am getting long starts. It's worth noting that I switched the exhaust and intake position sensors about a month because I got an OBD code that said one of them was bad. What could this be? Any help would be appreciated!! |
05-27-2020, 05:26 AM | #2 | |
Lieutenant Colonel
655
Rep 1,893
Posts |
Quote:
|
|
Appreciate
0
|
05-27-2020, 10:44 PM | #3 |
New Member
0
Rep 9
Posts |
The general code I got before that prompted me to switch the sensors was P0365. The code didn't come back after I erased it
Last edited by basedphenom; 05-27-2020 at 10:45 PM.. Reason: Left out information |
Appreciate
0
|
05-28-2020, 08:45 AM | #4 | |
Lieutenant Colonel
655
Rep 1,893
Posts |
Quote:
This suggests you should just replace the intake (formerly exhaust) cam sensor. Unless when you said "switched" sensors actually meant you replaced them both, rather than swapped them. |
|
Appreciate
1
feuer4282.50 |
Bookmarks |
Tags |
335i, codes., half engine light, mechanical problem, n54 335i |
|
|