|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Hello Colorado, Goodbye 2020
|
|
12-22-2020, 04:02 PM | #1 |
Major nutz
90
Rep 1,489
Posts
Drives: '09 n54 e92xi, 6mt, kw v3
Join Date: Sep 2009
Location: Colorado, USA
|
Hello Colorado, Goodbye 2020
Still have my '09 e92 that I bought new.
107,570 miles. Only drove it about 300 miles this year with Covid... Still pulls hard. In the 11 years since I bought it from (now gone) Murray Motors in Denver: Oil changes every 4k or so (sometimes more frequent) HPFP @5k - warranty Used Brembo BBK @ ~10k Numerous brake fluid flush/bleed/replacements New spark plugs every 10k or so 40k miles Battery replacement 02 sensors replacement 1 walnut blast @ ~ 42k (oil catch install at that time too --> really helps, checked @85k, need to check again) Between 50k and 60k miles Fuel Injectors VC (cracked) and gasket replaced Alternator replacement (twice, but because original replacement also went bad ) Oil filter housing gasket replacement (same time as alternator, 'cause the alternator is a PIA, and helps to remove oil filter housing) Trans & front/rear diff and TC fluid replacement (need to do again) Right front half-shaft (CV joint) replacement 80k miles Water Pump & thermostat replacement Car has been trouble free since the water pump. To do: Front hub replacement Possible left front half shaft replacement Diff & Transmission fluid replacement Possible walnut blast Still like this car and enjoy working on it, even though engine bay makes if feel like you are working on a 10# of s#!t in a 5# bag.
__________________
Last edited by IN54NITY; 08-26-2021 at 05:45 PM.. |
01-20-2021, 12:18 PM | #2 | |
Lieutenant Colonel
286
Rep 1,594
Posts |
Quote:
|
|
Appreciate
0
|
Bookmarks |
|
|