[slayerx]

Firstly my setup is factory hifi head unit, bav sound stage 1 front and back with their tweeters, factory under seat woofers powered by jl audio xd600/6, a single jl audio 10w3 2ohm powered by a jl audio jd500/1. With the technic pnp harness

I got a jl audio twk 88 for free brand new so I am installing that. I have my input to the twk from the technic harness as front left and right and rear left and right, and select the input on the twk set to that option.

My question is for the speaker configuration selection I see there is one for front l/r tweeter/mid (passive) >< woofer><sub> rear l/r speakers ( HP) There is nothing for a single sub option even this option sets it up as having two subwoofers. and my sub amp is mono so only has one input of left and right but when I look at the speaker output router of the twk it shows a left and right sub how do I set it to only output to a single sub?

As for the cross over what should I set the fronts to I can set both high and low points(I belive that's what they are called)?
Also what should the woofers points be set to on the crossover section in twk?
And what should rear speakers and subs be set to for xovers?

This is the first time using a dsp and setting cross overs.
I Am guessing I want the fronts and rears to be full range
Woofers to be mid bass and subs to be bass correct?

Thanks in advance and I hope I don't screw anything up trying to tune this dsp

[mweisdorfer]

Check out the two videos in this thread. It will give you some ideas

JBL MS-8 Processor Integration Thread https://www.e90post.com/forums/showthread.php?t=394375