![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
![]() |
![]() ![]() |
BMW 3-Series (E90 E92) Forum
>
Please help N54
![]() |
![]() |
12-16-2021, 11:04 AM | #23 |
Enlisted Member
![]() 1
Rep 32
Posts |
Did you have to reset solenoid adaptations? After swapping them out for the new ones
|
Appreciate
0
|
12-16-2021, 08:17 PM | #24 |
Enlisted Member
![]() 1
Rep 32
Posts |
Did you have to reset transmission adaptations or anything?
|
Appreciate
0
|
01-07-2022, 01:16 PM | #25 |
Brigadier General
![]() 2114
Rep 3,811
Posts |
NO....don't reset the adaptations. Just drive the car around like normal, letting it shift up and down through the years. It will reset/adjust the adaptations on it's own.
__________________
2007 335i, BMS DCI, BMS Chargepipe w/Tial BOV, ARM Catless Downpipes, silicone inlets, Bilstein B12 Prokit Suspension, Whiteline subframe bushings, Front/Rear M3 control arms, G-Plus FMIC, Stage 2 LPFP, Custom E40 tune by Justin (V8Bait), xHP stage 3 transmission flash, RB Two Turbos....10.90 @ 128mph
![]() |
Appreciate
0
|
04-30-2022, 10:22 AM | #26 |
Enlisted Member
![]() 1
Rep 32
Posts |
Hello guys thanks for everyone’s help I finally was able to buy the solenoids and replaced all of them now I’m just waiting for it to settle down to flash it with the XHP, I took it on a little drive and after I did the fluid and the sleeves and also solenoids it’s still did it again on fourth gear hopefully after I flash it with the xHP this issue will be resolved do I have to wait to do it or can I do it right away any help would be greatly appreciated. Thanks.
|
Appreciate
0
|
04-30-2022, 10:25 AM | #27 |
Enlisted Member
![]() 1
Rep 32
Posts |
Did flashing it with the Xhp help and did you flesh it right after you did the service of the sleeves and the solenoids and fluid or did you wait to do it
|
Appreciate
0
|
04-30-2022, 10:35 AM | #28 |
Brigadier General
![]() 2114
Rep 3,811
Posts |
If it was me I would put a couple hundred easy miles of driving on the transmission to let it adjust the adaptations.....and then put xHP on it. Make sure you check the line pressure bump option.
|
Appreciate
0
|
![]() |
Bookmarks |
|
|