01-06-2023, 01:34 AM | #67 |
Private
8
Rep 63
Posts |
|
Appreciate
0
|
01-08-2023, 11:29 AM | #69 |
Private
82
Rep 80
Posts |
Just done mine today,
Can confirm no fuse puller by the looks of it anymore. Also the Bimmerlink App worked fine on the new iDrive 8 version to open the valve. You can also put the car in sport but I actually found on a previous BMW the valve would only half open when in sport. So I wanted to use Bimmerlink to make sure it was fully open. You can also just about see the valve when you look at an angle. If I get any issues I will post but looks ok for now. |
Appreciate
0
|
01-08-2023, 09:01 PM | #70 | |
Lieutenant
171
Rep 401
Posts
Drives: G42,570GT,Lp5704STS,F36,F34
Join Date: Sep 2011
Location: Toronto
iTrader: (0)
Garage List 2023 BMW m240i [10.00]
17 Mclaren 570GT [9.50] 12 Lambo Supertrofe ... [0.00] 04 Lambo Gallardo ( ... [0.00] 08 Aston Martin Van ... [0.00] |
Quote:
|
|
Appreciate
0
|
01-09-2023, 07:26 AM | #71 |
Private
82
Rep 80
Posts |
|
Appreciate
0
|
01-11-2023, 02:37 PM | #72 | |
Private
8
Rep 63
Posts |
Quote:
|
|
Appreciate
0
|
01-11-2023, 02:58 PM | #73 | |
Private
82
Rep 80
Posts |
Quote:
I know putting it in sport probably does the exact same but I wanted to use Bimmerlink to make sure it was all the way open after issues on a previous car where the valve would only open 3/4 of the way when in sport and idle. No settings were needed, Bimmerlink is a little different to Bimmercode and you don't need to select a car from the list on the app. Just plug in and connect. |
|
Appreciate
1
icycoldd7.50 |
02-10-2023, 04:29 PM | #74 |
Private First Class
173
Rep 149
Posts |
Based on the start date of this thread, I suspect that most of those who pulled the F203 fuse are for MY 2022 with an iD7 operating system.
Can those with a MY 2023 with iD8 system confirm this still work? Is there any error message or check lights? |
Appreciate
0
|
02-11-2023, 01:07 PM | #75 |
Private
95
Rep 83
Posts |
I pulled that fuse on my 2023 and it didn't make a difference.
|
Appreciate
0
|
02-11-2023, 02:57 PM | #76 |
Captain
740
Rep 706
Posts |
Didlya have it in sport mode and warmed up, running. so the flapper was actually open when you pulled it? Ain't gonna work otherwise. All you are doing is deactivating the circuit that controls that flapper if the valve is closed when ya pull it...we you just made sure it will stay closed.
|
Appreciate
0
|
02-11-2023, 04:00 PM | #77 | |
Private First Class
153
Rep 177
Posts |
Quote:
I’d love to code out the auto stop/start and reset the default setting for individual sport mode |
|
Appreciate
0
|
02-11-2023, 04:34 PM | #78 | |
Private
95
Rep 83
Posts |
Quote:
|
|
Appreciate
0
|
02-11-2023, 05:29 PM | #79 | |
Private First Class
293
Rep 150
Posts |
Quote:
Alltough on cold start the car is louder. The flaps are still closed!! You have to wait till the car runs warm and you will hear the flaps open up in Sport(+) Only then pull the fuse. Next time you’ll cold start… braise yourself, it will be LOUD. And yes, it still works just the same for MY2023 |
|
Appreciate
0
|
02-12-2023, 10:53 AM | #81 | |
Private
82
Rep 80
Posts |
Quote:
I think the i4 recently got added which is iDrive 8 so there is hope. |
|
Appreciate
1
bobkat09153.00 |
04-25-2023, 08:35 AM | #82 |
Colonel
1790
Rep 2,118
Posts |
|
Appreciate
0
|
06-28-2023, 12:56 PM | #83 |
Retired USA
6
Rep 15
Posts |
2023 X3 Exhaust flap actuator
I looked at my X3 M Sport left side exhaust while the engine was off and it had sat over-night, and the flap was open. I pulled the fuse and now no matter what mode it is in, the exhaust flap actuator is WIDE OPEN.
|
Appreciate
1
MPR1828.00 |
Post Reply |
Bookmarks |
|
|