Rod bearings failure

atan14 · 09-13-2024, 12:36 PM

Hello, I’m pretty sure I spun a rod bearing. Haven’t dropped the oil pan (garage is full), but do you guys think the block is ok? I had to drive it a few miles on it knocking really loud and grinding. Thinking about going the built route and dropping in new pistons rods and looking at the 4n 2.6L destroker kit.

Lots of metal in oil filter btw
Thanks!

AWD Addict · 09-13-2024, 02:45 PM

You'll likely not know until you get in there, and see how the rod turns.

Driving it after it was spun is bad. Wouldn't take much to bend the rod. "Lots" of metal" is also not a great sign.

09-13-2024, 12:36 PM	#1
atan14 Enlisted Member 5 Rep 33 Posts Drives: 2014 328i Join Date: Oct 2022 Location: GA iTrader: (0)	Rod bearings failure Hello, I’m pretty sure I spun a rod bearing. Haven’t dropped the oil pan (garage is full), but do you guys think the block is ok? I had to drive it a few miles on it knocking really loud and grinding. Thinking about going the built route and dropping in new pistons rods and looking at the 4n 2.6L destroker kit. Lots of metal in oil filter btw Thanks!
	Appreciate 0 Tweet Quote

09-13-2024, 02:45 PM	#2
AWD Addict Chief Executive 382 Rep 2,917 Posts Drives: 2008 335xi 6spd Coupe Join Date: Dec 2007 Location: Boston iTrader: (1) Garage List 2008 335xi [0.00]	You'll likely not know until you get in there, and see how the rod turns. Driving it after it was spun is bad. Wouldn't take much to bend the rod. "Lots" of metal" is also not a great sign.
	Appreciate 2 whyzee1251990.50 atan144.50 Quote