|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
ATM Intercooler Issue
|
|
09-18-2024, 10:11 PM | #1 |
Private First Class
17
Rep 138
Posts |
ATM Intercooler Issue
Does anyone have any experience with installing the ATM intercooler? I am having an issue getting the hot side aluminum adapter installed fully onto the turbo. I cannot get the adapter to go any further than it currently is. By tomorrow the loctite will have been cured. I am pretty worried as I don't really know where to go from here. How would I even get the adapter off? Am I over reacting and it's on enough? I'm working on the car using ramps and laying on my back so I can only get so much force at a weird angle to hit the adapter onto the turbo.
Last edited by e90Noobie; 09-18-2024 at 10:19 PM.. |
09-19-2024, 10:39 PM | #2 |
Lieutenant
104
Rep 585
Posts |
Dunno if that's a strictly ATM issue and I have no experience with that, but it's not making that much pressure. I wouldn't worry about it until something goes wrong. All it'll do if that happens is go slow, sound funny and throw codes.
|
Appreciate
0
|
09-20-2024, 10:33 AM | #3 |
Private
9
Rep 55
Posts |
That green loctite is going to seal fine, I wouldn't worry about it. It's designed so you don't have to (or want to) remove that adapter...just the t clamp and hose.
If you absolutely have to remove that adapter for something in the future, heat is the only thing that will allow the green loctite to liquify and you'd likely have to tap it off. |
Appreciate
0
|
09-25-2024, 09:30 PM | #6 |
makes poor financial decisions
8
Rep 64
Posts |
Just make sure its tapped on there as good as you can, looks like you have a 1/4" before its fully seated that should be fine.
Also make sure the silicone hose doesn't touch the frame horn and you'll be alright. Its important to really clean the mating surface well, any burrs from the oring / OE charge pipe coupler could be why its not going further. |
Appreciate
0
|
Bookmarks |
|
|