[RACE M3]

Originally Posted by stoked335d

Do tuxmats smell ? How are they holding up?

My car has almost 20k miles(full leather), and everyone's first reaction is always....the car smells like new. They look brand new and i wear a variety of shoes. No scuffs that are apparent and no wear. I'm close to passing the mileage in my s2000, even though ive had them twice as long. No regrets!

Initial install didn't didn't add a toxic glue smell. My wife and kids have never commented on the 3 sets ive bought either. I'll admit i'm very sensitive to sound(drone) but when it comes to smell i'm rarely the first to criticize but i picked full leather for the new smell to last longer than the feeling.

I just sniffed a set in my wifes new daily thats 2-3 months and the trunk mat has no scent. As soon as i open the door I only smell delicious filets and ribeye ;-)

[stoked335d]

I ordered Maxpider 3D mats few days ago and installed them yesterday. I can confirm that they do fit on a 2020 330i Xdrive. Ordered from Amazon and was gonna return them if fit was bad since it is advertised for a RWD only. Only concern I have is the rear end of the front mats are a bit flat near the seat rails. Other version of 3D mats I have in my X3M are more raised to hold off water/slush better. Will try to get some pics

[RACE M3]

Originally Posted by stoked335d

I ordered Maxpider 3D mats few days ago and installed them yesterday. I can confirm that they do fit on a 2020 330i Xdrive. Ordered from Amazon and was gonna return them if fit was bad since it is advertised for a RWD only. Only concern I have is the rear end of the front mats are a bit flat near the seat rails. Other version of 3D mats I have in my X3M are more raised to hold off water/slush better. Will try to get some pics

Can you share close up pictures of the material? It looks cool in pictures!


The main thing that held me back was the logo. Is it sewn in or if removed will leave a mark of some sort? It looks like its just glued on. I wasn't able to get a clear answer whether its removable when i was shopping around.

[stoked335d]

Originally Posted by RACE M3

Can you share close up pictures of the material? It looks cool in pictures!


The main thing that held me back was the logo. Is it sewn in or if removed will leave a mark of some sort? It looks like its just glued on. I wasn't able to get a clear answer whether its removable when i was shopping around.

The material really looks cool. Don’t think removing the logo will look good. If you look at the pic showing bottom of the mat you’ll see what I mean. Saw someone Velcro an ///M logo on top of it in the F97 forum.

Sorry for the dirt that didn’t get a chance to clean up after my daughter’s XC 5K race from few days ago.

[ptek]

Originally Posted by RACE M3

They fit rwd cars perfect! I will say that I did trim mine a little around the clutch pedal. I remove it every week to clean and don’t want to spend 5-10 min tweaking to prevent any rubbing. I ride mtb 3x a week and track a lot of crap on the driver side.

Any tips on how you trimmed it for the clutch? Have a 6spd also and it make a slight noise when clutch is pressed to the floor.

[Yuille36]

I have these same floor mats for both my F85 X5M and F80 M3 ZCP. I truly love these mats, easy to clean, and the look fantastic.

[RACE M3]

Originally Posted by ptek

Any tips on how you trimmed it for the clutch? Have a 6spd also and it make a slight noise when clutch is pressed to the floor.

I used painters tape to mark the floor mat so I could see where exactly it’s hitting. I used a razor and ruler to get nice cuts. I trimmed a little at a time to not overdo it and giv dirt a way down.