|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Help!! No start no crank multiple codes
|
|
09-30-2024, 11:44 PM | #1 |
Registered
0
Rep 3
Posts |
Help!! No start no crank multiple codes
Hey, I have a 2011 328i. I was driving on the highway when my car suddenly stalled. I heard no noises or seen any oil leaks, so I immediately pulled over to start the car again. The car still has power but has no crank; it only turns over for a second when it is left alone for a day or two. I took the battery for a test, and the result came back bad, so I replaced it, but still no luck. I also changed the oil to see if there was anything odd but everything seemd fine. Im hoping to narrow the the problem. Below are the test results. TEST RESULTS •P0306 Power Train System Cylinder 6 Misfire Detected •P0306 Cylinder 6 Misfire Detected •P0491 Secondary Air Injection System (Bank 1) •P0015 Exhaust Camshaft Position Timing - Over-Retarded (Bank 1) •P0304 Cylinder 4 Misfire Detected •P0305 Cylinder 5 Misfire Detected •P0303 Cylinder 3 Misfire Detected •P0302 Cylinder 2 Misfire Detected •P1625 Pedal Position Sensor Potentiometer Supply Channel 2 Electrical •P1224 Pedal Position Sensor 1 and 2 Circuit Range/Performance •P10FD VVL-Sensors Circuit Low •P0123 Throttle/Pedal Position Sensor A Circuit High Input •P0222 Throttle/Pedal Position Sensor B Circuit Low Input •P110D Throttle Position Sensor A and B Circut range/ pefromance Last edited by e90.Alex; 09-30-2024 at 11:46 PM.. |
10-01-2024, 11:40 AM | #2 | |
Brigadier General
3013
Rep 4,358
Posts |
Quote:
All 6 of the fault codes above may be caused by Lack of Power Supply. That power comes from the DME when KL87 (DME Main Relay) is active. F37 on the JB Fuse Panel under glovebox should have battery voltage when Ignition is ON. ISTA ScreenPrints showing Voltage supply to DME, Accelerator Pedal module Voltage Supply, and ESS Supply, along with F37 Location, are attached to NEXT post. However, if you have NO Starter Cranking, or it only cranks for one second or less, then you have OTHER issues. So please answer the following: Questions: 1) Make/Model of any Scan Tool or diagnostic software available? 2) Are there any OTHER Fault Codes in DME (Engine Control Module) Memory, other than listed by you? Ignore any misfire codes. 3) If your Scan Tool/Software can display Freeze Frame Data, please provide that data for each fault above. 4) Can your Tool display Fault Memory of CAS Module? That would provide information related to any "NO Crank" issue. 5) Do you have a multimeter? 6) Do you have AT (Automatic Trans) vs. MT? 7) When you turn on Ignition, (WITHOUT pressing Brake/Clutch) does Instrument Cluster Light? Does Climate Control Panel light & Blower work? 8) If AT, can you shift from Park with Ignition ON & foot on Brake? 9) If so, does Gear Selected appear in lower Instrument Cluster display (P,R,N,D)? 10) Do Brake lights light when brake pedal pressed with Remote Key inserted? With answers to questions above, we can furnish "Next Steps" which YOU can perform with equipment available. Minimum Requirement: $10 Multimeter. George |
|
Appreciate
1
BRG_N54380.00 |
10-01-2024, 11:50 AM | #4 |
Brigadier General
3013
Rep 4,358
Posts |
Here are BMW Fault Code Lookup Fault Info Sheet Links for the 6 fault codes listed in previous codes. NOTE the Service Notes:
https://bmwfault.codes/XMLDiagView?d...E4NTgxNjcwNQ== https://bmwfault.codes/XMLDiagView?d...E4Njg2OTUwNQ== https://bmwfault.codes/XMLDiagView?d...E4NTg5NjMwNQ== https://bmwfault.codes/XMLDiagView?d...E4NjkzOTYwNQ== https://bmwfault.codes/XMLDiagView?d...E4NjkzOTUwNQ== https://bmwfault.codes/XMLDiagView?d...E4NTEzMjkwNQ== George |
Appreciate
0
|
10-01-2024, 10:13 PM | #5 | |
Registered
0
Rep 3
Posts |
Quote:
Hey thanks for the help 1. I used AutoZone loan-a-toll fix finder scanner 2. N/a At this moment 3. N/a At this moment 4.N/a At this moment 5.Yes I have a multimeter 6.Auto trans 7.Yes instrument cluster lights up and climate control with blower works 8.Yes I’m able to shift 9.Gears appear on lower cluster display(P,R,N,D) 10.Yes breaks light up when pressed on I'm glad to proceed to the next steps with your help.. AlexLast edited by e90.Alex; 10-01-2024 at 11:45 PM.. |
|
Appreciate
0
|
10-04-2024, 07:10 PM | #6 | |
Registered
0
Rep 3
Posts |
Quote:
Hey I was wondering if you can give me some feedback. Thank you |
|
Appreciate
0
|
Bookmarks |
|
|